TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-4.
Pump Assembly. (Sheet 8 of 23)
DISASSEMBLY (cont)
Protective plate must be used
to prevent damage to the
highly finished face of
barrel when removing bearing.
44.
Using protective plate and
suitable puller, remove bearing
(96, Figure 10-33).
45.
Remove items 97 thru 130 as an
assembly from fixture and install
on block.
Do not remove second ring.
Large spring in center of
barrel is under compression
and release of spring by
removal of second ring may
cause INJURY.
46.
Remove ring (97) from shaft (120,
Figure 10-34).
47.
Remove eight bolts (98), lock-
washers (99), two covers (100),
shim(s) (101 and 102) and two
preformed packings (103) from
body (118, Figure 10-35).
Discard preformed packings (103).
48.
Remove two bearings (104).
Go to Sheet 9
10-22
CAUTION
WARNING
Figure 10-34.
Figure 10-35.
Figure 10-33.