TM 5-3805-261-34
STEERING MAINTENANCE. (cont)
8-5. Steering Cylinder. (Sheet 3 of 6)
REMOVAL (cont)
5.
Remove cotter pin (11), nut (12) and washer
(13, Figure 8-14). Discard cotter pin (11).
6.
Remove items 18 thru 20 as an assembly from
axle bracket by prying or pulling and from wheel
spindle housing by using socket removing tool.
7.
Remove spacer (14), bearing (15), spacer (16)
and ring (17).
NOTE
Before removing socket and nut, measure
and record the amount of exposed threads
on the threaded rod to aid in installation.
8.
Loosen nut (19) while holding hex (21, Figure
8-15) end of rod.
9.
Remove socket (18) and nut (19) by unscrewing
from cylinder (20).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Go to Sheet 4
8-14
Figure 8-15.
Figure 8-14.
