TM 5-3805-261-34STEERING MAINTENANCE.8-5.SteeringCylinder.(Sheet 6 of 6)ADJUSTMENTNOTEThe toe-in is correct if the front distance is0.12 inch to 0.25 inch less than the reardistanced.9.Loosen two nuts on clamps at ends of tie-rod.10.Turn rod until toe-in is 0.12 inch to 0.25 inch. Tighten rod to 55 ft-lb torque.11.Loosen nut (19) on cylinder rod while holding hex (21) on left steering cylinder.12. Turn hex (21) all the way on threaded rod of socket (18).13.Repeat step 12 for right steering cylinder.14.Turn hex (21) until right spindle stop is 0.12 inch from right axle stop.15.Tighten nut (19) while holding hex (21) on cylinder rod.16.Turn front wheels all the way to the right.17.Repeat step 16 so that right wheel spindle stop is 0.12 inch from left axle stop.18.Remove jack stands and hydraulic jack.19.Remove leaning wheel lock pin.NOTEReturn 130C Grader to original equipment condition.End of Task8-17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
