TM 5-3805-261-34
STEERING MAINTENANCE. (cont)
8-4.
Steering Control Pump. (Sheet 4 of 5)
ASSEMBLY (cont)
NOTE
Lubrication may be necessary for assembly.
2.
Install retainer (31), ball (30), new preformed packing
(29), seat (28), new preformed packing (27) and screw
(26) in pump body (32, Figure 8-9). Tighten screw (26)
to 8 ft-lb torque.
3.
Install new preformed packing (25), items 35 thru
33 as an assembly and snap ring (24) in pump
body (32).
4.
Install spool (22), sleeve (21) and pin (20, Figure 8-8).
5.
Install six springs (23) in spool (22) and sleeve (21).
Make sure the curves of the springs (23) are in
contact and in center of spool.
6.
Install race (19), bearing (18), race (17), spool
and items 23 thru 20 as an assembly into items
35 thru 24 as an assembly (Figure 8-7).
7.
Pin (20) in sleeve assembly must be in alinement
with gear (12, Figure 8-12).
Go to Sheet 5
8-10
Figure 8-12.
Figure 8-8.
Figure 8-9.
Figure 8-7.
