REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_498

REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_500

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
452

TM 5-3805-261-34 REAR AXLE MAINTENANCE. (cont) 5-23. Final Drive Assembly. (Sheet 10 of 10) INSTALLATION (cont) 22. Install two 5/8-llNC eyebolts in items 9 and 8 as an assembly (Figure 5-143). 23. Using hoist and sling, position items 9 and 8 as an assembly on lower rear, left side of vehicle. 24. Install washer (7), shim(s) (6). retainer (5), 16 washers (4) and bolts (3). 25. Apply grease to washer (7) after installation. Adjust shim(s) (6) to provide 0.0 to 0.0025 inch end play between inner housing (39) and outer housing (8). Tighten 16 bolts (3) to 260 to 280 ft-lb torque. 26. Remove two 5/8-llNC eyebolts. 27. Install roller bearing (2) and new preformed packing (1, Figure 5-125). NOTE Return 1300 Grader to original equipment condition. End of Task 5-112 Figure 5-143. Figure 5-125.

Privacy Statement
Press Release
Contact