TM 5-3805-261-34
REAR AXLE MAINTENANCE. (cont)
5-23.
Final Drive Assembly. (Sheet 6 of 10)
REMOVAL (cont)
17.
Remove retaining ring (27) and
washer (28) from planetary
carrier (29, Figure 5-136).
18.
Remove eight bolts (30), four
locks (31) and plates (32) from
housing (39, Figure 5-137).
19.
Remove gear (33).
20.
Remove items 34 and 35 as an
assembly.
21.
Using suitable puller, remove
roller bearing (34) from shaft
(35, Figure 5-138).
22.
Using suitable puller, remove and
discard cup (36) and seal (37)
from housing (39, Figure 5-139).
23.
Remove and discard cup (38).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Lower temperature of new cup (38)
and install in housing (39,
Figure 5-140).
2.
Lubricate new seal (37) with oil
and install with lip of new seal
(37) toward new cup (36).
Figure 5-136.
Figure 5-137.
Figure 5-138.
Figure 5-139.
Figure 5-140.
Go to Sheet 7
5-108
