REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_492

REAR AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_494

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
446

TM 5-3805-261-34 REAR AXLE MAINTENANCE. (cont) 5-23. Final Drive Assembly. (Sheet 4 of 10) REMOVAL (cont) 5. Remove plug (9) and seal (10) from outer housing (8, Figure 5-129). 6. Remove rings (11 and 12) and washer (13, Figure 5-130) from lower rear, left side of vehicle. Discard seal (13). 7. Remove 19 nuts (14) and washers (15). 8. Using saddle and floor jack, support items 16 thru 39 as an assembly. Use rags between saddle and floor jack and items 16 thru 39 as an assembly (Figure 5-131) to prevent damage to housing. Weight of housing is approxi- mately 360 lbs. Use adequate hoist and sling for lifting. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 9. Install two 3/4-10NC forcing screws in housing (39). Tighten each forcing screw a small amount at a time, alternating between screws, until housing (39) has been moved far enough out on the studs to install a bracket and hoist on housing (39). Put axle in position in housing (39) to keep items 16 thru 39 as an assembly in balance. Using bracket and hoist, carefully remove items 16 thru 39 as an assembly from vehicle. Make sure planet carrier (29, Figure 5-132) is held in place during removal. TM 5-3805-261-34 WARNING Figure 5-129. Figure 5-130. Figure 5-131. Figure 5-132. Go to Sheet 5 5-106

Privacy Statement
Press Release
Contact