FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_459

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_461

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
413

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. 5-15. Wheel Spindle, Bearing and Seals. (Sheet 6 of 7) INSTALLATION 18. Position seal (8) and ring (7) in spindle (11, Figure 5-94). With ring (7) still wet, use seal installer to position seal (8) and ring (7) squarely against spindle (11). 19. Install seal (8) and ring (7). With sudden and even pressure on the seal installer push to seat ring (7) under retaining lip of spindle (11). 20. Adjust seal (8) and ring (7), if necessary, using seal installer. 21. Inspect ring (7) for twists or bulges. Incorrect installation will result in seal failure. If incorrect installation is obvious, repeat step 16. 22. Clean seal (8) mating surface with a lint free cloth. If any dirt particles remain on seal face, seal (8) will leak. 23. Lubricate mating surface of seal (8) with gear lubricant. 24. Loosen bolt (18) and nut (19, Figure 5-85). 25. Install items 11 thru 7 as an assembly in housing (17). NOTE Use care not to damage seals and rings. Figure 5-94. Figure 5-85. Go to Sheet 5 5-73

Privacy Statement
Press Release
Contact