FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_443

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_445

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
397

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. 5-13. Front Axle Assembly. (Sheet 4 of 4) INSTALLATION 5. Install washer (10) and pin (8). Use washer (9) only if required to obtain a maximum gap of 0.06 inch between axle (13) and vehicle frame. Hole in pin (8) must aline with hole in axle (13, Figure 5-72). 6. Install washer (5) and pin (4). Hole in pin (4) must aline with hole in axle (13). 7. Remove hoist and sling. 8. Install bolt (7), nut (6), bolt (3) and nut (2, Figure 5-73). 9. Remove jack stand (Figure 5-66). 10. Lubricate and install six fittings (1, Figure 5-67). Refer to LO 5-3805-261-12. NOTE Return 130G Grader to original equipment condition. End of Task 5-57 Figure 5-72. Figure 5-73. Figure 5-67. Figure 5-66.

Privacy Statement
Press Release
Contact