STARTING SYSTEM MAINTENANCE. (cont)

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_323

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_325

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
278

TM 5-3805-261-34 STARTING SYSTEM MAINTENANCE. 4-9. Starting Motor (Delco-Remy). (Sheet 15 of 15) ADJUSTMENT 1. Disconnect wire assembly (11, Figure 4-53) from solenoid. 2. Connect solenoid to 24 volt battery, as shown, using three jumper wires. Do not connect ground to MTR terminal at this time. Check pinion clearance quickly to avoid damage to solenoid windings. 3. Momentarily flash jumper wire "A" from ground to MTR terminal. Drive (48, Figure 4-54) will shift into cranking position. 4. Press drive (48) in direction of arrow to take up slack. 5. Using thickness gage, measure pinion clearance. 6. Adjust lock nut (3) until correct clearance. 7. Remove three jumper wires (Figure 4-53). 8. Install new preformed packing (2) and plug (1) in housing (58, Figure 4-55). 9. Connect wire assembly (11, Figure 4-56) to solenoid ground. NOTE Return 130G Grader to original equipment condition. End of Task 4-51 CAUTION Figure 4-53. Figure 4-54. Figure 4-55. Figure 4-56.

Privacy Statement
Press Release
Contact