TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE. (cont)
4-9.
Starting Motor (Delco-Remy). (Sheet 12 of 15)
ASSEMBLY (cont)
NOTE
Install brush holders with
side bracket of brush holder
to the outside of plate (34).
20.
Install plate with stud (32),
brush holder (30), insulator
(33), screw (27), spring guide
(28), spring (29), insulator (33)
and screw (26) on plate (34,
Figure 4-43).
21.
Install plate (31), brush holder
(30), screw (27), spring guide
(28), spring (29) and screw (26).
22.
Install plate (31), brush holder
(30), insulator (33), screw (27),
spring guide (28), spring (29)
and screw (26).
23.
Install plate (31), brush holder
(30), screw (27), spring guide
(28), spring (29) and screw (26).
24.
Install four brushes (25) and two
screws (24). When installing
four new brushes (25), if
necessary, check to be sure
brushes (25) ride freely in brush
holders (30).
25.
Install washer (23) on plate (34,
Figure 4-42).
26.
Using suitable driver and press,
install new bushing (21), if
removed, in end frame (22).
27.
Install new insulator (20) in end
frame (22).
28.
Coat new preformed packing (19)
with general purpose grease and
position on end frame (22).
Go to Sheet 13
4-48
Figure 4-43.
Figure 4-42.
