TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE.
4-9.
Starting Motor (Delco-Remy). (Sheet 9 of 15)
CLEANING
2.
Remove loose particles from
armature (46, Figure 5-49) with
compressed air and wipe with a
clean cloth dampened with dry
cleaning solvent. Clean commuta-
tor lightly with sandpaper and
remove all traces of dust with
low pressure compressed air.
3.
Clean all other parts. Refer to
Chapter 2.
INSPECTION
1.
If any of four brushes (25) are
worn more than half when compared
to a new brush, replace all four
brushes (25, Figure 4-50).
2.
Check four holders (30, Figure
4-51) for dirt. Four brushes
(25) must not bind in brush
holders (30). Springs on brush
holders (30) must hold brushes
(25) firmly against commutator.
Replace brush holders (30) if
defective.
3.
Inspect all other parts. Refer
to Chapter 2.
Figure 4-51.
Go to Sheet 10
4-45
Figure 4-49.
Figure 4-50.
