TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE. (cont)
4-9.
Starting Motor (Delco-Remy). (Sheet 4 of 15)
DISASSEMBLY (cont)
14.
Remove and discard preformed
packing (19) and insulator (20)
from end frame (22, Figure 4-42).
NOTE
Removal of bushing from end
frame will cause destruction
of bushing. Remove bushing
only if inspection indicates
replacement is necessary.
15.
Inspect bushing (21) and if
necessary, using a suitable
driver and press, remove bushing
(21) from end frame (22).
16.
Remove washer (23) from plate
(34).
17.
Remove two screws (24, Figure
4-43).
NOTE
Mark locations of brushes to
aid in installation.
18.
Separate four brushes (25) from
brush holders (30).
19.
Remove four screws (26), four
screws (27), four spring guides
(28), four springs (29), four
brush holders (30), three plates
(31), plate and stud (32) and
three insulators (33) from plate
(34).
Go to Sheet 5
4-40
Figure 4-42.
Figure 4-43.