TM 5-3805-261-34
CHARGING SYSTEM MAINTENANCE. (cont)
4-5.
Alternator (Bosch). (Sheet 4 of 12)
DISASSEMBLY (cont)
15. Remove four screws (18) and washers (19,
Figure 4-22).
CAUTION
Use care not to damage stator with screwdrivers
when prying from frames.
16. Using two screwdrivers, separate items 20 thru
27 as an assembly from items 28 thru 54 as an
assembly.
17. Position items 20 thru 27 as an assembly in
arbor press.
CAUTION
Removal of rotor from frame may cause destruction
of bearing.
18. Using an arbor press, remove rotor (20, Figure
4-23).
19. Remove spacer (21) from items 22 thru 27 as an
assembly.
CAUTION
Epoxy putty covers wire assembly. Care must be
taken when removing this epoxy so wire assembly is
not damaged.
20. Disconnect field coil (24) wire assembly at two
terminals from inner frame (27, Figure 4-24).
21. Remove six screws (22) and lockwashers (23).
Figure 4-22.
Figure 4-23.
Figure 4-24.
Go to Sheet 5
4-26
