CHARGING SYSTEM MAINTENANCE. (cont)

CHARGING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_287

CHARGING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_289

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
242

TM 5-3805-261-34 CHARGING SYSTEM MAINTENANCE. 4-4. Alternator (Delco). (Sheet 11 of 18) ASSEMBLY 3. Install new bearing (77), if removed. Press from the inside of housing (80) on the seal portion of new bearing (77) until new bearing (77) is a depth of 0.640 to 0.650 inch. 4. Using lubricant, fill housing (80, Figure 4-15) reservoir half full. Arrange lubricant so a portion will touch bearing (77). 5. Install new plug (76, Figure 4-10), tapping evenly with soft hammer. 6. Using lubricant, lubricate grommet (74) lightly. 7. Position field coil (75). Pull field coil (75) wires through bore in housing (80). Seat grommet (74) in hole and aline field coil (75) mounting holes. 8. Install three screws (73). 9. Install new insulator (71), new grommet (70) and three new terminals (69) to stator (72), if removed. 10. Using lubricant, lubricate new grommet (70) lightly. 11. Position stator (72) alining matchmarks. 12. Install stator (72) by pulling stator (72) wires through bore in housing (80). Seat new grommet (70) in bore, if removed. Figure 4-15. Go to Sheet 12 4-15

Privacy Statement
Press Release
Contact