TM 5-3805-261-34
CHARGING SYSTEM MAINTENANCE. (cont)
4-4.
Alternator (Delco). (Sheet 6 of 18)
DISASSEMBLY (cont)
22. Remove insulator (47, Figure 4-6).
23. Remove three studs (48) and insulators (49)
from heat sink (51).
CAUTION
Removal of positive diode wire assemblies from heat
sink may cause destruction. Remove only if
inspection
or
testing
indicates
replacement
is
necessary. Refer to testing procedures in this
paragraph.
24. Support heat sink (51) and remove three positive
diode wire assemblies (50) at terminals, if
necessary.
25. Remove plug (52, Figure 4-7).
26. Remove screw (53) and lockwasher (54).
27. Remove four screws (55) and washers (56).
CAUTION
Use care when prying frame and rotor assembly
from stator. Do not damage stator with screwdrivers.
28. Using two screwdrivers, separate items 57 thru
68 as an assembly from items 69 thru 80 as an
assembly.
29. Position items 57 thru 68 as an assembly in
suitable press.
Figure 4-6.
Figure 4-7.
Go to the Sheet 7
4-10
