TM 5-3805-261-34
CHARGING SYSTEM MAINTENANCE.
4-4.
Alternator (Delco). (Sheet 13 of 18)
ASSEMBLY
19. Install race (59, Figure 4-17), if removed. Press
on rotor (57) shaft until depth of 0.145 to 0.150
inch is made.
20. Install collar (65) through new seal (63) in
retainer (62).
21. Using lubricant, lubricate retainer (62), collar (65)
and new gasket (64). Fill reservoir between
retainer (62) and collar (65) three-quarters full so
at least a portion will contact bearing (66) after
assembly. Position in frame (68).
22. Install four washers (61) and screws (60).
23. Using a suitable press, support collar (65) and
press rotor (57) into retainer (62).
24. Install collar (58) on rotor (57).
Figure 4-17.
Go to Sheet 14
4-17
