TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-30.
Governor Controls. (Sheet 16 of 21)
INSTALLATION
49.
Position shaft (35) in housing (40, Figure 3-157).
50.
Install key (34) in shaft (35).
51.
Install lever (36) on shaft (35) in housing (40).
52.
Install shaft (35) into housing (40).
53.
Tighten bolt (37).
54.
Position cable (61) in housing (40).
55.
Install two nuts (33).
56.
Install nut (32), actuator (31) and rod end (30)
on cable (61).
57.
Aline lever (36) and rod end (30).
58.
Install two springs (29), washer (28) and bolt (27).
59.
Install nut (26) and bolt (25) in actuator (31).
60.
Position items 40 thru 25 as an assembly, new
gasket (24) and housing (23) on cover (130,
Figure 3-156).
61.
Install two washers (22) and bolts (21).
62.
Install key (16) in shaft (35, Figure 3-155).
63.
Install lever (15) on shaft (35).
64.
Install bolt (14) and nut (13).
Figure 3-155.
Go to Sheet 17
3-183
Figure 3-156.
Figure 3-157.
