TM 5-3805-261-34FUEL SYSTEM MAINTENANCE. (cont)3-30.GovernorControls.(Sheet 15 of 21)INSTALLATION (cont)42.Position cable (61) in lower slot of backing clamp(46, Figure 3-174) on right and left sides of articulationarea.43.Install one of two clamps (46), plates (45), two clips(44), washers (43) and nuts (42) loosely. Securehoses to clips (44). Do not tighten nuts (42) atthis time.44.Position cable (61) through lower articulation areato left side of vehicle. Position cable (61) in lowerslot of clamp (46).45.Install one of two clamps (46), plates (45), clips(44), two washers (43) and nuts (42) loosely.Secure hose to clips (44). Do not tighten two nuts(42) at this time.46.Position cable (61) from articulation area up to rightside of engine compartment.47.Using suitable driver and hammer, install newbearings (39 and 38, Figure 3-161), if removed.Drive new bearings (39 and 38) on stamped sideinto housing (40).48.Install bolt (37) in lever (36, Figure 3-158).Go to Sheet 163-182Figure 3-158.Figure 3-161.Figure 3-174.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
