TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-30.
Governor Controls. (Sheet 20 of 21)
ADJUSTMENT
13.
Install bolt (72), washer (71) and nut (70).
Check distance between floor and lever (87)
again.
NOTE
The following adjustment dimension
is for a vehicle equipped with a floormat.
14.
Loosen nuts (76 and 81).
15.
Adjust treadle (80) so top of treadle extends 0.38
inch above operator’s compartment floor.
16.
Tighten nuts (81 and 76).
17.
Position handle (127) on operator’s control
console. Pull back towards rear of vehicle into
high idle position.
18.
Adjust high idle bolt (109) under right side of
operator’s compartment until contact with
lever (105) is made.
19.
Tighten one nut (108).
20.
Loosen nut (77).
21.
Adjust treadle (82) so that a distance of 2.38
inches between floor and bottom of plate on
treadle is obtained.
22.
Tighten nut (77).
23.
Adjust bolt (70) until contact with lever (87) in
high idle position is made.
24.
Tighten nut (71).
Go to Sheet 21
3-187
