TM 5-3805-261-34FUEL SYSTEM MAINTENANCE.3-30.GovernorControls.(Sheet 10 of 21)REMOVAL80.Remove and discard cotter pin (112, Figure 3-170)from right side of operator’s control console inoperator’s compartment.81.Remove pin (113).82.Separate items 114 thru 119 as an assemblyfrom handle (129).83.Remove items 114 thru 119 as an assemblyfrom vehicle.84.Loosen nuts (115 and 117, Figure 3-171).85.Remove rod end (114), nut (115), rod end (116),nut (117), boot (118) and rod (119).86.Remove nut (120), washer (121), seat (122),six springs (123), washer (124), items 126 thru129 as an assembly and disc (125, Figure 3-172).NOTERemove bearing only if inspectionindicates replacement is necessary.87.Inspect bearing (126, Figure 3-173). Replace ifcracked, broken or worn.88.Using suitable driver and hammer, removebearing (126), if necessary.89.Remove handle (127) from stud (128).90.Remove stud (128) from handle (129).Go to Sheet 113-177126Figure 3-173.Figure 3-172Figure 3-171.Figure 3-170.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
