TM 5-3805-261-34FUEL SYSTEM MAINTENANCE.3-28.Governor. (Sheet 2 of 17)REMOVAL1.Remove four bolts (1), two bolts(2 and 3) and bolt (4, Figure3-110) from governor and fuelinjection pump assembly.2.Separate items 6 thru 65 as anassembly and gasket (5) from fuelinjection pump and center housingassembly. Discard gasket (5).Remove all gasket material frommounting surfaces.3.Remove spring (6), two washers(7), washer (8) and seat (9) fromguide (36, Figure 3-111) on reargovernor housing.4.Remove six bolts (10), cover (11)and gasket (12). Discard gasket(12). Remove all gasket materialfrom mounting surfaces.5.Using suitable driver and hammer,remove and discard seal (13).6.Remove items 14 thru 65 as anassembly.7.Remove items 20 thru 27 as anassembly and levers (14 and 15,Figure 3-112).8.Remove screw (16), nut (17) andwashers (18 and 19). Discardwasher (19).9.Remove four rings (20) from twopins (21, Figure 3-113).10.Remove two pins (21), plates (22)and stop (23).11.Remove dowel (24), pin (25) andspring (26) from shaft (27).Go to SheetFigure 3-110.Figure 3-111.Figure 3-112.Figure 3-113.3-145
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
