TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-27.
Governor and Fuel Injection Pump. (Sheet 5 of 9)
STATIC FUEL ADJUSTMENT
NOTE
Perform the next step if
testing indicates static fuel
setting is incorrect.
20. Remove two bolts (9), cover (10)
and gasket (11, Figure 3-106)
from rear governor housing.
Discard gasket (11). Remove all
gasket material from mounting
surfaces.
21. Using rack adjustment tool,
loosen lock nut (12).
22. Using rack adjustment tool,
adjust screw (13). Turn screw
clockwise to decrease the static
fuel setting. One half turn of
the setscrew will change reading
on dial indicator approximately
0.016 inch. Turn until reading
of 0.056 inch is obtained.
NOTE
It may be necessary to make
an adjustment to torque rise
by loosening lock nut (14)
and adjusting screw (15) to
obtain proper adjustment of
power adjustment screw (13).
23. Tighten lock nut (12).
24. Install new gasket (11), cover
(10) and two bolts (9). Remove
indicator bracket tooling from
fuel injection pump.
Go to Sheet 6
3-139
