TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-25.
Fuel Injection Pump. (Sheet 15 of 16)
INSTALLATION (cont)
6.
Install three nuts (7, Figure
3-84).
7.
Install manifold shield. Refer
to paragraph 3-19, step 6.
8.
Install governor control lever.
Refer to paragraph 3-30.
CAUTION
After the fuel injection pump
and governor are installed,
move governor control lever
back and forth. Preformed
packing can hold rack and
prevent free movement. If
rack does not move freely,
remove fuel injection pump
and governor and reset
preformed packing.
9.
Connect hose assembly (3).
10. Install hose assembly (6), new
preformed packing (5) and elbow
(4).
11. Position linkage assembly (53) on
governor control lever.
12. Install pin (2) and new cotter
pin (1).
CAUTION
Do not attempt to start
engine until fuel injection
pump and governor have been
adjusted.
13. Install fuel injection pump drive
gear. Refer to paragraph 3-7.
14. Install fuel transfer pump.
Refer to paragraph 3-29.
15. Install starting motor. Refer to
TM 5-3805-261-20.
Go to Sheet 16
3-130
Figure 3-84.