TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-26.
Fuel Injection Pump Mounting. (Sheet 2 of 3)
REMOVAL
1.
Remove bolt (1) and washer (2,
Figure 3-98) from front, right
side of engine.
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
2.
Disconnect wire assembly (3) at
terminal.
3.
Remove bolts (4, 5, 6 and 7),
support (8) and preformed
packings (9, 10, 11 and 12).
Discard preformed packings (9,
10, 11 and 12).
4.
Remove plugs (13, 14 and 15) from
support (8).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
Go to Sheet 3
3-133
Figure 3-98.