TM 5-3805-261-34
ENGINE MAINTENANCE.
3-14.
Valve Cover. (Sheet 2 of 2)
REMOVAL
1.
Remove 11 bolts (1) and lock-washers (2,
Figure 3-69) from top of engine.
2.
Separate cover (3) and gasket (4) from
cylinder head. Do not pry on lip of cover (3).
Discard gasket (4). Remove all gasket
material from mounting surfaces.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
INSTALLATION
1.
Position new gasket (4) and cover (3, Figure
3-69) on cylinder head. Apply gasket cement
to lip of cover (3), where gasket (4) makes
contact. Install gasket (4).
2.
Install 11 lockwashers (2) and bolts (1).
Tighten bolts (1) to 10 ft-lb torque.
NOTE
Return 130G Grader to original equipment
condition.
Figure 3-69.
End of Task
3-87