TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-16.
Oil Pump and Lines. (Sheet 2 of 6)
REMOVAL
1.
Remove bolts (1 and 2, Figure 3-71) from
bottom of engine.
2.
Support items 8 thru 18 as an assembly.
3.
Remove two bolts (3), locks (4), bolts (5) and
washers (6).
4.
Remove items 8 thru 18 as an assembly and
gasket (7) from elbow (19).
5.
Remove and discard gasket (7) from engine.
Remove all gasket material from mounting
surfaces.
6.
Remove two bolts (8), lock (9), bell (10) and
gasket (11, Figure 3-72) from oil pump
assembly. Discard gasket (11). Remove all
gasket material from mounting surfaces.
7.
Using suitable puller, remove gear (12).
CAUTION
Removal of bearing from gear will
cause destruction of bearing. Remove
bearing only if inspection indicates
replacement is necessary.
8.
Inspect bearing (13). Replace if cracked,
broken, distorted, grooved or scored.
9.
Using suitable driver and press, remove
bearing (13) if necessary.
Go to Sheet 3
3-92
Figure 3-71.
Figure 3-72.
