ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_123

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_125

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
79

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-9. Cylinder Head Assembly. (Sheet 3 of 8) REMOVAL NOTE All hose and tube assemblies should be tagged before disconnecting to aid in installation. Cap all hose and tube ends to prevent contamination. 1. Remove tube (1) from tube assembly (37) and atomizer (2, Figure 3-35) on top, left side of engine. 2. Remove atomizer (2) from cylinder head (18). 3. Disconnect tube assembly (3). 4. Remove elbow (4). 5. Disconnect tube assembly (5). 6. Remove connector (6) and bushing (7). 7. Loosen two clamps (39) on left side of engine. 8. Remove hose (8) by sliding back off pipe (40). 9. Remove bolts (9 and 10) and two bolts (11, Figure 3-36) from front, left side of engine. 10. Separate elbow (12) from cylinder head (18) and water pump. 11. Remove and discard gaskets (13 and 14). Remove all gasket material from mounting surfaces. 12. Remove five bolts (15), 14 bolts (16) and washers (17) from top of cylinder head (18). Go to Sheet 4 3-52 Figure 3-36. Figure 3-35.

Privacy Statement
Press Release
Contact