TM 5-3805-261-34
FRAME MAINTENANCE.
16-2.
Frame Separation and Connection. (Sheet 11 of 12)
INSTALLATION
20.
Position heater hose (35) on
heater and install clamp (34,
Figure 16-7).
21.
Position heater hose (33) and
install clamp (32).
22.
Install clip (31), washer (30)
and bolt (29).
23.
Position cable assemblies (28, 27
and 26, Figure 16-5) on vehicle.
24.
Set cable assemblies (28, 27 and
26, Figure 16-6) into
transmission control valves.
25.
Move three couplings (25) forward
on cable assemblies (28, 27 and
26) and position over
transmission control valves.
26.
Slide retainer (24) forward.
27.
Install three nuts (23, Figure
16-5). Tighten three nuts (23).
28.
Install two washers (22) and
bolts (21).
29.
Install clamp (20), plate (19),
clip (18), two washers (17) and
nuts (16, Figure 16-4) under
right, rear of cab.
Go to Sheet 12
16-13
Figure 16-
Figure 16-
Figure 16-
Figure 16-
