TM 5-3805-261-23-2
WHEEL SPINDLE, BEARINGS, AND SEALS REPLACEMENT - CONTINUED
0302 00
INSTALLATION - CONTINUED
20
3.
Install new seal (20) on ring (19). Ensure seal is not
20
twisted and is seated properly on bottom of ring ramp
and against retaining lip.
4.
Install seal inserter on seal (20) and ring (19) as an
RAMP
assembly.
19
19
RETAINING LIP
397-4183
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and other sources of ignition. Failure to follow this warning may cause
injury or death to personnel.
5.
Use seal inserter to lower seal (20) and ring (19) as an
SEAL
assembly into container of solvent cleaning compound
INSERTER
until completely wet.
20
19
397-4184
6.
Position seal (20) and ring (19) in housing (10). With
SEAL INSERTER
ring still wet, use seal inserter to position seal and ring
20
as an assembly squarely against housing.
7.
Install seal (20) and ring (19). With sudden and even
10
pressure on the seal inserter, push to seat ring under
RETAINING
retaining lip of housing (10).
LIP
397-4185
19
0302 00-4