TM 5-3805-261-23-2
REAR SIGNAL LIGHT AND BACKUP ALARM WIRING HARNESS REPLACEMENT - CONTINUED
0285 00
INSTALLATION
CAUTION
Do not position rear signal light and backup alarm wiring harness against any rough surface. Failure to fol-
low this procedure may cause chafing.
NOTE
Route rear signal light and backup alarm wiring harness exactly as it was removed.
1.
Position rear signal light and backup alarm wiring harness (9) in machine.
2.
Connect wire assembly (16) to rear signal light and backup alarm wiring harness (9).
3.
Install rear signal light and backup alarm wiring harness (9) into clip (14).
4.
Connect wire assembly (15) to rear signal light and backup alarm wiring harness (9).
5.
Install rear signal light and backup alarm wiring harness (9) into clip (13).
6.
Connect wire assembly (11) to rear signal light and backup alarm wiring harness (9).
7.
Install rear signal light and backup wiring harness (9) into clip (18).
8.
Connect wire assembly (12) to rear signal light and backup alarm wiring harness (9).
9.
Install rear signal light and backup alarm wiring harness (9) into clip (19).
10.
Connect two wire assemblies (17) to rear signal light and backup alarm wiring harness (9).
11.
Connect rear signal light and backup alarm wiring harness (9) to rear work light wiring harness (3).
12.
Install new tie strap (4).
13.
Install clip (2), washer (5), and bolt (6).
14.
Connect rear signal light and backup alarm wiring harness (9) to main wiring harness (7).
15.
Install three clips (1), washers (10), and nuts (8).
16.
Connect battery cables (WP 0125 00).
17.
Install radiator grill (WP 0054 00).
18.
Close engine screen doors (TM 5-3805-261-10).
END OF WORK PACKAGE
0285 00-3/(-4 Blank)