TM 5-3805-261-23-1
STEERING CYLINDER REPLACEMENT - CONTINUED
0176 00
REMOVAL
NOTE
This procedure covers maintenance for the left steering cylinder. Follow these instructions for the right
steering cylinder.
1.
Remove bolt (12), washer (13), clip (11), and pin (10).
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate the skin, causing injury to personnel.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulic lines. Failure to follow this warning may cause injury to personnel.
CAUTION
Cap hose ends and plug open ports to prevent contamination.
NOTE
Tag hose assemblies before disconnecting to aid in installation.
2.
Disconnect hose assemblies (1 and 5) and remove O-rings (2 and 6) from cylinder (9). Discard O-rings.
3.
Remove elbow (3) and preformed packing (4). Discard preformed packing.
4.
Remove connector (7) and preformed packing (8). Discard preformed packing.
2
1
3
4
12
13
11
56789
10
397-2285
0176 00-2
