TM 5-3805-261-23-1
REMOTE CONTROL REPAIR (TYPE II MACHINE) - CONTINUED
0175 00
DISASSEMBLY
CAUTION
Cap hose and tube ends and plug all open fuel ports to prevent contamination.
NOTE
Tag hose and tube assemblies and wires before disconnecting to aid in installation.
2
1.
Disconnect hoses (1, 2, 3, and 4) from elbows (5, 7, 9,
1
and 11).
3
2.
Open cover (15).
3.
Remove line fittings from elbows inside remote con-
trol unit (13).
4.
Remove elbows (5, 7, 9, and 11) and preformed pack-
ings (6, 8, 10, and 12) from remote control unit (13).
4
Discard preformed packings.
5.
Tag and disconnect wiring inside remote control unit
(13). Disconnect wiring harness (14) at fitting and
14
remove wiring harness from remote control unit.
5,6
13
11,12
9,10
7,8
397-2357
6.
Loosen jamnuts securing cable assemblies (17, 19, and 20) to remote control unit (13) and remove cable assemblies.
7.
Remove steering valve (23) by removing nuts (22 and 24), wire (21), and disconnecting tubes ends (25, 26, and 33).
8.
Remove differential lock switch (18) by disconnecting wires (27, 28, 29, and 30) and removing switch from cover (15).
9.
Remove low air warning lamp (16) by disconnecting wires (31 and 32) and removing lamp from cover (15).
0175 00-2
