TM 5-3805-261-23-1
SUPPLEMENTAL STEERING GOVERNOR SWITCH MAINTENANCE - CONTINUED
0088 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0021 00.
INSTALLATION/ADJUSTMENT
1.
Install rod (14), two new spring-tension washers (12), bolt (13), actuator (15), and nut (16) to clevis (11).
NOTE
Do not tighten nut.
2.
Install nut (9) on adjusting screw (10) and install screw on actuator (15).
3.
Install cover (8) and three bolts (7).
4.
Install new gasket (6), housing (5), two washers (17), and bolts (18) to cover (8).
5.
Install nut (20) and new preformed packing (19) on switch (21) and install switch to housing (5) with a distance of 0.75
in. (19 mm). Tighten nut to 15 lb-ft (20 Nm).
6.
Pull accelerator pedal upward from cab floor to engine shutoff position (TM 5-3805-261-10).
7.
Connect multimeter leads to switch (21) terminals. Turn adjusting screw (10) inward until multimeter shows continuity.
Then rotate one more turn.
8.
Tighten nut (9) on adjusting screw (10).
9.
Install new gasket (4), cover (3), four washers (2), and bolts (1) to housing (5).
10.
Connect two wire assemblies (22) to switch (21) and install two washers (23) and screws (24).
11.
Close right side engine doors (TM 5-3805-261-10).
12.
END OF WORK PACKAGE
0088 00-3