TM 5-3805-261-23-1
SECONDARY FUEL FILTER AND MOUNTING MAINTENANCE
(MODELS 130G, 130GSCE, AND 130GNSCE) - CONTINUED
0047 00
INSTALLATION - CONTINUED
6.
Turn priming pump knob on right side of fuel tank to the left to release pump knob.
7.
Pump until pressure makes knob difficult to pump.
8.
Turn knob right to lock in place.
9.
Turn fuel injection pump valve, on right side of engine, to the left to open, allowing air to release through hose outlet at
lower part of engine. Close valve.
NOTE
Repeat steps 7 through 10 until fuel, flowing through drain hose, is free of all air bubbles.
10.
Turn battery disconnect switch to ON position and start engine (TM 5-3805-261-10).
11.
Check for leaks. Stop engine.
NOTE
If engine was running roughly, perform the next step. If not, proceed to step 14.
12.
Bleed air from fuel injection pump lines in top of fuel injection pump (WP 0035 00).
13.
Close right side engine doors (TM 5-3805-261-10).
END OF WORK PACKAGE
0047 00-5
