TM 5-3805-261-23-1
ELECTRICAL SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
0008 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
d. Inspect and clean ground
If starter is still inoperative, go to Test 4.
5.
Starting Motor Is Inoperative
connections on back of starter and
- Continued.
tighten nut.
3.
Test starter circuit source voltage.
a. Place battery disconnect switch in
OFF position.
b. Place multimeter to appropriate
voltage range (WP 0021 00).
c. Connect multimeter positive lead
to "BAT" terminal on solenoid and
negative lead to chassis ground.
d. Place battery disconnect switch in
If battery voltage is indicated, go to Test 5.
ON position.
G
MTR
S
CONNECTOR
(+)
(-)
BAT
397-2422
e. Check battery connections.
Repair or replace broken wire(s) between
battery and starting motor (WP 0021 00).
f. If battery disconnect switch and
If the problem still exists, go to Test 4.
connections are OK, check wiring
4.
Check starting motor voltage.
a. Connect meter positive lead to
solenoid terminal MTR and
negative lead to chassis ground.
b. Place battery disconnect switch to
ON position.
0008 00-5
