TM 5-3805-261-20
BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE.
14-9.
Heater. (Sheet 5 of 7)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
ASSEMBLY
1.
Install bracket (46) and four nuts (45) on
bracket assembly (44) in heater assembly
(8, Figure 14-24).
2.
Install bracket assembly (44).
3.
Install knob (43).
4.
Connect cable assembly (42).
5.
Install nut (41).
6.
Install two switches (40) and nuts (39).
7.
Connect two wire assemblies (38 and 37) at
connectors.
8.
Connect two wire assemblies (36 and 35,
Figure 14-23) at connectors.
9.
Connect two wire assemblies (33) at
terminals to connector (34).
10.
Install resistor (32), clip (31) and bolt (30).
11.
Connect wire assembly (35) at terminal on
resistor (32).
12.
Install brush (28), screw (27) and cap (26)
on motor (29).
13.
Install washer (25) on motor (29).
Go to Sheet 6
14-37
