REMOVAL - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
881

TM 5-3805-261-20 BODY, CHASSIS AND HULL ACCESSORY ITEMS MAINTENANCE. (cont) 14-9. Heater. (Sheet 2 of 7) REMOVAL 1. Remove seat. Refer to paragraph 13-21, steps 1 and 2. 2. Remove six bolts (1), washers (2) and cover (3, Figure 14-21) from front seat support in operator’s compartment. NOTE All wire, cable and harness assemblies must be tagged before disconnecting to aid in installation. 3. Disconnect wire assembly (4) from connector (34). 4. Remove and discard grommet (5). 5. Pull heater wiring harness out of heater assembly (8). 6. Loosen clamp (47). NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. 7. Disconnect hose (6) from outlet. 8. Loosen clamp (48). 9. Disconnect hose (7) from valve (9). 10. Remove bolt (10), lockwasher (11), clip (12) and washer (13) from right side of plate (14) of heater assembly (8). 11. Remove bolt (15) and washer (16) from left side of heater assembly plate. 12. Remove heater assembly (8) from front seat support. Figure 14-21. Go to Sheet 3 14-34

Privacy Statement
Press Release
Contact