TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
13-10. Cab Doors and Latch Assemblies. (Sheet 9 of 9)
INSTALLATION
31.
Install two washers (11), nuts (10) and
screws (9).
32.
Install two spacers (8), plate (7), two
washers (6) and nuts (5, Figure 13-31).
33.
Install three spacers (4), plate (3), three
washers (2) and nuts (1).
34.
Remove hoist and sling.
35.
Connect cab switch panel. Refer to
paragraph 7-43, steps 6 and 10.
ADJUSTMENT
1.
Close doors, left and right sides (Figure 13-
42).
2.
Inspect striker (65) to see if striker (65) is
centered in latch (62) and does not guide
the door up or down.
3.
Adjust,
if
necessary,
by
removing
or
installing shims (66).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 13-31.
Figure 13-42.
End of Task
13-43
