TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-29.
Articulation Lines, Fittings and Hoses. (Sheet 4 of 7)
REMOVAL
13.
Remove hose assemblies (30 and 31,
Figure 15-135) from articulation cylinder
from
under
right
side
of
engine
compartment.
14.
Remove connector (32), preformed packing
(33), connector (34) and preformed packing
(35). Discard preformed packings (33 and
35).
15.
Remove bolt (36), washer (37) and clamp
(38, Figure 15-136).
16.
Remove hose assemblies (39 and 40) from
articulation cylinder from under left side of
engine compartment.
17.
Remove connector (41), preformed packing
(42), connector (43) and preformed packing
(44). Discard preformed packings (42 and
44).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install
new
preformed
packing
(44),
connector (43), new preformed packing (42)
and connector (41, Figure 15-136) to
articulation cylinder under left side of engine
compartment.
2.
Install hose assemblies (40 and 39).
3.
Install clamp (38), washer (37) and bolt
(36).
Figure 15-135.
Figure 15-136.
Go to Sheet 5
15-159
