REMOVAL - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
1021

TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. 15-26. Leaning Wheel Hoses and Fittings. (Sheet 2 of 7) REMOVAL NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends and plug all open hydraulic ports to prevent contamination. 1. Disconnect four hose assemblies. Refer to paragraph 15-24, steps 1 and 2 and paragraph 15-32, steps 1 and 2. 2. Disconnect hoses (19 and 20, Figure 15- 106) from right control valve group. 3. Remove connector (1), preformed packing (2), connector (3) and preformed packing (4). Discard preformed packings (2 and 4). 4. Remove two bolts (5), washers (6), clamp (7), two spacers (8) and clamp (9, Figure 15-107). 5. Remove bolt (10), washer (11) and clamp (12, Figure 15-108) from right side, center section of frame. Figure 15-107. Figure 15-106. Figure 15-108. Go to Sheet 3 15-137

Privacy Statement
Press Release
Contact