TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-26.
Leaning Wheel Hoses and Fittings. (Sheet 4 of 7)
REMOVAL
10.
Disconnect hoses (30 and 31, Figure 15-
111) from bottom of leaning wheel check
and relief valve.
11.
Remove connector (25), preformed packing
(26), connector (27) and preformed packing
(28). Discard preformed packings (26 and
28).
12.
Remove and discard strap (29). Cut to
remove.
13.
Remove hoses (30 and 31) from leaning
hydraulic cylinder.
14.
Remove elbow (32), preformed packing
(33), elbow (34) and preformed packing
(35) from leaning wheel hydraulic cylinder.
Discard preformed packings (33 and 35).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 15-111.
Go to Sheet 5
15-139
