6
TM 5-3805-293-23-5
FIELD MAINTENANCE
-
TORQUE LIMITS
0
348
SCOPE
000348
This work package lists standard torque values and provides general information for applying torque. Special
torque values and tightening sequences are indicated in the maintenance procedures for applicable components.
GENERAL
000348
1. Always use torque values listed in Tables 1 and 2 when a maintenance procedure does not give a specific
torque value.
a. Table 1 provides torque limits for SAE standard fasteners.
b. Table 2 provides torque limits for metric fasteners.
2. Unless otherwise indicated, standard torque tolerance shall be 10 percent.
3. Torque values listed are based on clean, dry threads. Reduce torque by 10 percent when engine oil is used as
a lubricant. Reduce torque by 20 percent if new plated capscrews are used.
4. If the maintenance procedures do not specify a tightening order, use the following guides:
a. Unless otherwise specified, lubricate threads of fasteners with clean oil (OE/HDO-10).
b. When tightening fasteners above 30 lb-ft (41 Nm), use the torque pattern but tighten to only 70 percent of
final value (multiply final value by 0.7). Repeat pattern until final value is reached.
c.
Tighten circular patterns using circular torque pattern, and tighten straight patterns using straight torque
pattern.
1
8
5
12
10
4
3
11
9
6
7
2
CIRCULAR TORQUE PATTERN
8
531246
9
7
STRAIGHT TORQUE PATTERN
C AU T I O N
If replacement capscrews are of higher grade than those originally supplied, use torque
specifications for the original. This precaution will prevent equipment damage due to
overtorquing.
0348-1
