TM 5-3805-293-23-5
0313
ASSEMBLY
000313
N OT E
Lubricate all O-rings and seals with a small amount of hydraulic oil before installation.
1. Install new wear ring (Figure 5, Item 6), new buffer seal (Figure 5, Item 5), new U-cup seal (Figure 5, Item 4),
new wiper seal (Figure 5, Item 2), new backup ring (Figure 5, Item 14), and new O-ring (Figure 5, Item 3) on
head (Figure 5, Item 1).
2. Install new wear ring (Figure 5, Item 12) and new seal (Figure 5, Item 11) on piston (Figure 5, Item 8).
3. Install head (Figure 5, Item 1) and piston (Figure 5, Item 8) on centershift cylinder rod (Figure 5, Item 13).
4. Install washer (Figure 5, Item 10) and bolt (Figure 5, Item 9) on centershift cylinder rod (Figure 5, Item 13).
Torque to 440 95 lb-ft (600 13 Nm).
5. Install centershift cylinder rod (Figure 5, Item 13) in centershift cylinder housing (Figure 5, Item 7) and tighten
head (Figure 5, Item 1).
END OF TASK
0313-7