TM 5-3805-293-23-5
0313
REMOVAL CONTINUED
3. Start engine and use machine hydraulics to retract centershift cylinder and stop engine (TM 5-3805-293-10).
4. Install vacuum cap (WP 0221).
5. Release centershift circuit pressure (WP 0218).
6. Disconnect lower hydraulic hose (Figure 2, Item 4) from fitting (Figure 2, Item 2).
7. Remove fitting (Figure 2, Item 2) and remove two O-rings (Figure 2, Item 3) from centershift cylinder (Figure 2,
Item 1). Discard O-rings.
Figure 2. Lower Hydraulic Hose.
0313
8. Disconnect upper hydraulic hose (Figure 3, Item 2) from fitting (Figure 3, Item 3).
9. Remove fitting (Figure 3, Item 3) and remove two O-rings (Figure 3, Item 4) from centershift cylinder (Figure 3,
Item 1). Discard O-rings.
Figure 3. Upper Hydraulic Hose.
0313