TM 5-3805-293-23-5
0309
ASSEMBLY
000309
N OT E
Lubricate all O-rings and seals with a small amount of hydraulic oil before installation.
1. Install new wear ring (Figure 5, Item 6), new buffer seal (Figure 5, Item 5), new U-cup seal (Figure 5, Item 4),
new wiper seal (Figure 5, Item 2), new backup ring (Figure 5, Item 14), and new O-ring (Figure 5, Item 3) on
head (Figure 5, Item 1).
2. Install new wear ring (Figure 5, Item 12) and new seal (Figure 5, Item 11) on piston (Figure 5, Item 8).
3. Install head (Figure 5, Item 1) and piston (Figure 5, Item 8) on cylinder rod (Figure 5, Item 13).
4. Apply a light coat of grease to bolt (Figure 5, Item 9).
5. Install washer (Figure 5, Item 10) and bolt (Figure 5, Item 9) on cylinder rod (Figure 5, Item 13). Torque to
1,328 lb-ft (1,800 Nm).
6. Install cylinder rod (Figure 5, Item 13) in cylinder housing (Figure 5, Item 7) and tighten head (Figure 5, Item 1).
END OF TASK
0309-7