TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
11. Using MSD (WP 0006), select
2252-08 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
08 is active.
this diagnostic code.
2252-08 Code Not Active -
Troubleshooting complete.
Test Step 4. Check Articulation
2252-08 Machine Articula-
tion Angle Sensor #2 Abnor- Angle Position Sensor 2 (Right).
mal Frequency, Pulse Width 1. Turn ignition switch and battery
or Period - Continued
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Install a jumper wire between
harness connector AT-C4 (WP
0009, Figure 122) terminal A and
terminal C.
3. Using MSD (WP 0006), verify
2252-03 Code Active - Proceed to
2252-03 is active.
step 4.
2252-03 Code Not Active - Proceed
to step 9.
4. Remove jumper wire from har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal A and termi-
nal C.
5. Install a jumper wire between har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal B and termi-
nal C.
6. Using MSD (WP 0006), verify
2252-04 Code Active - Replace
2252-04 is active.
articulation angle position sensor 2
(right) (WP 0257).
Proceed to step 7.
2252-04 Code Not Active - Proceed
to 8.
7. Using MSD (WP 0006), select
2252-08 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
08 is active.
this diagnostic code.
2252-08 Code Not Active -
Troubleshooting complete.
0031-148