TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-08 Machine Articula-
8.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor #2 Abnor-
continuity between rear chassis
Replace transmission ECM (WP
mal Frequency, Pulse Width
harness connector FA-C20 (WP
0137).
or Period - Continued
0009, Figure 113) terminal 44 and
Remove jumper wire between AT-C4
terminal 45.
(WP 0009, Figure 122) terminal A and
Resistance should be less than
terminal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Proceed to step 11.
Resistance More Than 5.0 Ohms -
Proceed to step 9.
9. Disconnect rear chassis harness
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
10. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between secondary
Replace rear chassis wiring harness
steering wiring harness AT-C1
(WP 0188).
(WP 0009, Figure 110) terminal 8
Remove jumper wire between AT-C4
and terminal 9.
(WP 0009, Figure 122) terminal A and
Resistance should be less than
terminal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Proceed to step 11.
Resistance More Than 5.0 Ohms -
Replace secondary steering wiring
harness (WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Proceed to step 11.
0031-147