TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-04 Machine Articula-
2. Using MSD (WP 0006) verify
2252-04 Was Active for the
tion Angle Sensor #2 Volt-
2252-04 was active for the
Transmission ECM Only - Replace
age Below Normal -
Transmission ECM or the
transmission ECM (WP 0137).
Continued
Implement 1 ECM.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 3.
2252-04 Was Active for the
Implement 1 ECM Only - Replace
implement 1 ECM (WP 0268).
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Connect rear chassis harness
connector FA-C21 (WP 0009, Figure
124) to transmission ECM J2 (WP
0009, Figure 112).
Proceed to step 3.
0031-142