TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-04 Machine Articula-
Test Step 3. Check for Shorted Rear
tion Angle Sensor #2 Volt-
Chassis Wiring Harness.
age Below Normal -
1. Turn ignition switch and battery
Continued
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
3. Disconnect rear chassis harness
connector FA-C20 (WP 0009,
Figure 113) from transmission
ECM J1 (WP 0009, Figure 112)
(WP 0137).
4. Disconnect rear chassis harness
connector FA-C21 (WP 0009, Fig-
ure 124) from transmission ECM
J2 (WP 0009, Figure 112).
5. Using digital multimeter, test for
Continuity - Proceed to Test Step 4.
continuity between rear chassis
No Continuity - Proceed to Test Step
harness connector FA-C21 (WP
5.
0009, Figure 124) terminal 17 and
machine ground. There should be
no continuity.
Test Step 4. Check for Shorted Sec-
ondary Steering Wiring Harness.
1. Disconnect rear chassis harness
connector FA-C5 (WP 0009,
Figure 111) from secondary
steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0031-140